![]() ![]() If you are using a dual-band AP, try to enable Band Steering to redirect the 5GHz-capable clients to the 5GHz SSID. Deploy 5GHz Wi-Fi and Enable Band SteeringĥGHz radio is usually much less crowded than the 2.4 GHz band so that it can offer better Wi-Fi performance. Channel Bandwidth option is on Wireless LAN > Advanced Setting page. However, if there is a lot of interference, lower the bandwidth to 20MHz so it would use only one least-crowded channel. Stay on the default settings if there's not much interference on your network. It recommends the best channel based on the traffic on each channel (Channel Utilization), as well as the electromagnetic field detected on each channel (Channel Energy, not necessarily generated by APs, can also by the electronic devices).īy default, the wireless channel bandwidth is 20/40MHz, which means the router or AP may use two 20MHz channels at the same time to double the throughput. Selected VigorAP also provides Interference Monitor under the Diagnostic menu. ![]() Channel settings are on Wireless LAN > General Setup page.ĪP Discovery shows the recommended channel to use at Statistics after a scan. You may use AP Discovery or Interference Monitor function to check the nearby AP and the channels they're using, then use a channel that is less used by the others. ![]() The Wi-Fi will have a lot of interference and start dropping packets if it is using a channel too crowded. Keep away from the obstruction and interference.Deploy 5GHz Wi-Fi and enable band steering.If your Wi-Fi speed is slow or you get disconnected quite often, you may try the following to improve the Wi-Fi performance of Vigor Router or VigorAP, including: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |